The correct management of laying hens in cascading egg cages
Under the development of aquaculture automation, the cascading laying hen cage mode has been widely recognized by the majority of laying hen farms. This farming method has a small footprint, high space utilization rate, and stratified cleaning of chicken manure, which can not only improve the utilization rate of chicken manure. It also reduces the degree of environmental pollution. At the same time, it reduces labor intensity and increases productivity.
Although cascading cages have many advantages, the premise is to know how to use them and how to manage them.
Stacked cellular equipment for laying hens (H type)
Due to the overlapping of multiple layers of cages, it is not convenient to catch chickens. The time for laying cages can be extended appropriately. Before the cages, vaccines such as Newcastle disease, infectious bronchitis, avian flu, and egg drop syndrome should be exempted. Finish. When the egg production rate reaches 5%, the prenatal feed should be replaced with a peak material. It takes a one-week transition period to replace the feed hens. At this time, the feed should be of good quality and the nutrient composition is stable. Do not replace the finished feed and raw materials at will.
2, in addition to the conventional power system, must match the generator of the chicken farm, and can automatically switch. Ensure that the lighting in the house is uniform, and the lamp can be installed in a wrong layer or used.
In order to ensure the service life of the equipment, the transmission parts such as the transmission gear transmission sprocket and gear are regularly lubricated once a month during use. Clean the surface of the egg feeding roller and the septic roller in time to prevent the accumulation of debris and cause the septic belt to burst or break the roller shaft. Clean up the impurities in the soft and broken egg collection trays in time. The ventilation system should be properly adjusted for side wall ventilation and roof ventilation depending on the season. The lighting bulb should be kept clean to prevent the light intensity from being affected.
full automatic manureremove machine for chickens chicken cage
3. If the roller is only driven when the manure is removed, the septic belt will not move, and the chicken manure may be stuck due to excessive chicken manure. The septic belt should be run regularly, and the bolts should be tightened at both ends of the drive roller to remove foreign matter. If the chicken manure on the manure belt is thin, it may be that the drinker is leaking, the joint at the sink is not well sealed, and the chicken is diarrhea. To replace the drinker, apply the sealant to the joint and apply for treatment.
Cages System with Automatic Feeder
4, if the car does not go, it may be driving the wheel, the rope does not move, the positioning plate on the driven wheel is not in contact with the travel switch, the track wheel and the guide rail are squeezed, the motor is damaged. At this time, it is necessary to rotate the ratchet of the skip, tighten the drawstring, adjust the position of the travel switch, make contact, correct the guide rails, make them parallel, and replace the motor.
Egg collection and sorting systems
5 If the egg breaking rate is high, it may be chicken quail eggs, the eggshell is thin, and the claws on the automatic egg collecting machine are broken. The eggs rolling off the cage net collide with the eggs on the egg belt, and come out from the automatic egg collecting machine. The eggs collide with the eggs on the central egg line. You can use the electric shock line, change the feed formula, find out the broken egg removal, use the egg line, adjust the egg height to make it cushion.
During the operation of the equipment, it is strictly forbidden to observe the running condition of the equipment and open the relevant inspection port for overhaul. During inspection, repair and maintenance, the staff must ensure that the main power switch is disconnected and the main power switch is blocked, otherwise serious injury may result. There are two travel switches installed on the nose and the tail of the machine. When the track wheel of the skip touches any of the travel switches, it will stop running. The check switch should be checked regularly for sensitivity. If it fails, it should be replaced in time. Otherwise, it will easily pull the material truck and even lead to more serious consequences.